Precautions for Drum Repair for Floor Tiles

1. Prepare adhesive
Before preparing a binder, the tile should not be soaked, but it should be used to remove the loose substances on the back of the tile with a steel wire, and wipe the dust on the back of the brick with a wet cloth. Then put the water or lotion in the mixing barrel as the proportion of the manufacturer until the bonding agent is uniform. The bonding agent after the initial mixing should be stated in the mixing barrel until it is stirred after the producer's recommended maturity time, so it is not easy to produce empty drums.

2. Tile
During the drying time of the bonding agent, the prepared tiles were put in place, and the vertical sorting direction was slightly rubbed to discharge the air under the tile. After the laid is put in place, use a rubber hammer to lightly strike, and use a suitable cross -positioning rack to adjust the flatness of the surface and the straightness of the seam.

3. Clean up in time
The paved brick surface should be cleaned in time, especially to remove the relics that remain on it. The qualified bonding agent is not easy to remove even on the ceramic tile surface. The clean tile surface should be immediately placed for isolation to avoid pollution or disturbance until the next sewing process.